Video transcript

Hello and welcome to another Antgrip tutorial where we will show you how to install Antgrip on your Logitech G 305. When you open the package for your Antgrip, inside you will have alcohol pads and the card with the grip. Before you start, take the card and try to figure out where the parts go you won’t have a problem with it later.

When you are ready to start – take an alcohol pad and clean your mouse. First we’re going to apply the mouse button parts because they’re easiest to apply.

We’re gonna check again, this part goes here, so peel it from the the card. Take your mouse and be careful to fit the side line of the grip with the side line of your mouse. First fit it in the edge and then fit the side lines of the grip with the side line of your mouse. When you’re happy with the fit, press it down gently.

Take another mouse part and repeat the same as before – fit in the edge and then watch it and fit the side line of your grip with the side line of your mouse. Now we’re going to carry on with the side parts, so take one side part and carefully apply it. Fit the side part with no buttons, press it down and then watch to again fit the bottom line of the grip to the bottom edge of the mouse. Don’t forget to press it down from the bottom up and then from the middle to the sides like I’m doing now.

Now you are ready for your next side part, so peel it down from the card and you’re gonna fit his side on the front of your mouse’s side like so and press it down with your finger – be careful so the curfes of your buttons fit the curves of your Antgrip.

Always start in the middle, so you don’t have any air pockets trapped underneath the grip.

Okay, so now we’re going to apply the hardest part, which is the full cover grip. We’re going to fit the edge right here to this edge here and when you have it fitted just right, press it with the other hand nad be careful that you follow the line of the grip on the side of the mouse. When you’re pressing it down you should go from the top right around the dge and around the back, as well as to the back from the top. Once again, be very careful to follow the lines of the mouse and press it down gently with your fingers, moving them from the top to the bottom.

Now that you have applied all the grip parts, you’re going to go back and pres thoroughly on every edge of the grip for a couple of seconds or so, which will ensure a better grip with the surfare – and when you’re done with this, you are ready to enjoy your Antgrip.

Additional information for this guide

N/A

Something not working?

Contact us.