Video transcript
Hello and welcome to another Antgrip tutorial where we will show you how to install Antgrip on your Razer DeathAdder. When you open the package for your Antgrip inside you will have alcohol pads and two cards with a grip. Before you start take cards and try to figure out where the parts go so you won’t have a problem with it later. When you are ready to start take an alcohol pad and clean your mouse of any potential greasiness.
First we’re going to apply this mouse grip to the part is the same in this case – carefully take it off so you don’t rip it right here and here okay and watch out so you fit this side part and this curve to the side part of your mouse and this curve right here like this. Press it down so when you have this gap here you press down the first side here and then you pull the other side of the grip towards it here so it fits without the gap. Now you just carefully press down the rest of the grip so it fits the curve of the mouse. Now again we have a gap – we press down the first side of the gap and then pull this side of the gap towards the other like this so the end result will be that you don’t have any gaps on your grip like this.
Okay so we’re done with the hard part. Now carry on with the next mouse side and again watch out so you fit the side curve and the sidelines of the grip with the sidelines and the curve right here. With the mouse like this press it down like this so it fits the curve of the mouse again like that. So if you apply it correctly the grip – on one side and the other side of the grip should not have the gap between them like this. Okay now we are ready to apply the first side part this is the one with with the buttons. Okay so first carefully fit this side with that line here – press down with one finger you still have the other side of the grip lift up lift it up and now press here and watch for the curve of the grip to fit the curve of your mouse like this. Press it down like this and it should fit perfectly like mine. Okay – now the last part of our that DeathAdder grip and again sit this side with that line and again until we are happy with the fit – just press it down have the other side of the grip still lifted up and then press it down like this so you fit the bottom line of the grip with the bottom edge of your mouse here. Press it down. Okay so when you’re done with all this you’re gonna have to go back to all the pieces that you applied and press down especially on the edges for a couple of seconds on each centimeter like this.
Additional information for this guide
N/A
